Zanussi ZOB10501 - Manual (Page 10)

Stainless steel or aluminium appliances:
Clean the oven door with a wet sponge only. Dry it
with a soft cloth.
Do not use steel wool, acids or abrasive materials, as they
can cause damage to the oven surface. Clean the oven
control panel with the same precautions.
Cleaning the door gasket
• Regularly do a check of the door gasket. The door gas-
ket is around the frame of the oven cavity. Do not use
the appliance if the door gasket is damaged. Contact
the Service Centre.
• To clean the door gasket, refer to the general informa-
tion about cleaning.
Acqua cleaning
The Acqua cleaning procedure uses steam to help remove
remaining fat and food particles from the oven.
1. Put 300 ml of water into the Acqua cleaning container
at the bottom of the oven.
2. Set the oven function .
3. Set the temperature to 90 °C.
4. Let the appliance operate for 30 minutes.
5. Deactivate the appliance and let it cool down.
6. When the appliance is cool, clean the inner surfaces
of the oven with a cloth.
Warning! Make sure that the appliance is cool
before you touch it. There is a risk of burns.
Oven lamp
Warning! Be careful when you change the oven
lamp. There is a risk of electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deactivate the cir-
cuit breaker.
Put a cloth on the bottom of the oven to prevent
damage to the oven light and glass cover.
Always hold the halogen lamp with a cloth to prevent
grease residue from burning on the lamp.
1. Turn the glass cover counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an applicable 300
°C heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has two glass panels. You can remove the
oven door and the internal glass panel to clean it.
The oven door can close if you try to remove the in-
ternal glass panel before you remove the oven door.
1 Open the door fully
and hold the two door
hinges.
2 Lift and turn the levers
on the two hinges.
3 Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove the door
from its seat.
4 Put the door on a soft
cloth on a stable surface.
5 Release the locking
system to remove the in-
ternal glass panel.
90°
6 Turn the two fasteners
by 90° and remove them
from their seats.
10
www.zanussi.com