Zanussi DE 6844 A - Manual (Page 9)

9
Rinse aid
Rinse aid is automatically added during the last
rinse, ensuring thorough rinsing, and spot and
streak free drying. The dispenser, which is
positioned inside the door, holds about 110 ml of
rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by turning the lid (A)
anticlockwise.
2. Add the rinse aid until the container is completely
full. The indicator (B) will be completely dark.
3. Top up the rinse aid when the rinse aid indicator
light on the control panel illuminates.
If rinse aid refilling is necessary, the rinse
aid indicator light will illuminate only in
setting mode and at the end of the
washing programme.
During the run of the programme it will
remain off.
It is possible to deactivate the rinse aid indicator
light (see the following instructions), By default the
rinse aid indicator light is active.
Ensure that the lid is closed after every refill.
Do not put liquid detergent in the rinse aid
compartment. Clean up any rinse aid spilt during
filling with an absorbent cloth to avoid excess
foaming during the next wash.
To deactivate the rinse aid indicator light
be sure that the dishwasher is off and
then proceed as follows:
1. Press INTENSIVE SID 80 and NORMAL
programme push buttons simultaneously.
2. While keeping the programme push buttons
INTENSIVE SID 80 and NORMAL pressed
switch on the dishwasher by pressing the
ON-OFF push button.
The ON-OFF indicator light comes on.
At the same time, the indicator lights of the
INTENSIVE SID 80 and NORMAL push buttons
start flashing.
BR01
A
m
ax
6 5 4 3
2
1
B
BR03
SO390