Zanussi DE 6755 - Manual (Page 11)

11
1. Check the filters
Ensure they are clean and properly positioned (see
"Maintenance and cleaning").
2. Press the ON-OFF push button
The ON-OFF indicator light will come on.
3. Check that there is rinse aid
and salt
The corresponding indicator lights will illuminate if refilling
is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely
6. Measure out detergent
Add the required amount of detergent into the dispenser
according to the recommended quantity given in the
Washing programmes chart.
Close the detergent dispenser lid.
7. Close the dishwasher door
8a. Setting and starting the programme
without DELAY START
Press the push button corresponding to the required
programme: the indicator light corresponding to the
programme illuminates and the phase indicator lights for
that programme start flashing.
The start of the programme will occur after about 6
seconds from the last pressure of a programme push
button, in this time it is possible to change programme
simply pressing the push button of another programme.
Once the programme has started the phase indicator
lights will turn off except for the phase under way.
It is possible to interrupt the programme by:
● opening the door
● pressing the ON-OFF (in this case all the indicator
lights turn off)
Close the door again or press the ON-OFF, the
programme will start from the point in which it was
interrupted.
8b. Setting and starting the programme
with DELAY START
The setting of the delay start occurs before selecting the
programme.
Press the DELAY START push button and selected the
desired time (3, 6 or 9 hours) until the indicator light
corresponding to the chosen hours flashes.
Press the push button corresponding to the required
programme: the indicator light corresponding to the
programme illuminates and the phase indicator lights for
that programme start flashing.
The start of the countdown will occur after about 6
seconds from the last pressure of a programme push
button.
The countdown will decrease with step of 3 hours and
you are informed of this by the indicator lights of the
hours.
During the countdown the only indicator lights illuminated
are the programme light and the light of the number of
hours to the start of the programme.
Once the delayed time has elapsed the programme will
start automatically.
It is possible to stop a countdown in progress or before it
starts, simply pressing the DELAY START push button
until the indicator lights of the hours are off.
9. To cancel a programme in progress
A programme in progress can be cancelled at any time.
Press for about 3 seconds the push button of the running
programme until all indicator lights are off.
Only the ON-OFF indicator light will remain on once the
programme has been cancelled.
It is now possible to select a new washing programme.
10. At the end of the washing
programme
The dishwasher will automatically stop and the phase
indicator light end of programme will come on.
The indicator light of the programme just ended will
remain on.
The dishwasher has finished the programme only when
the end of programme indicator light is illuminated.
If you do not wait for the end of the programme it will not
be possible to start a new programme if first you do not
cancel the previous.
(For instructions on how to cancel a programme see
point 9)
Switch off the dishwasher by pressing the ON-OFF push
button and open the door.
Wait a few minutes before removing the dishes; in this
way they will be cooler and drying will be improved.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Important!
In general it is not advisable to open the door while the
machine is working; if the door is opened however, a
safety device ensures that the machine stops.
Care must be taken if the door is opened during the hot
phase or immediately after a programme has finished, as
steam may escape.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Operating sequence