Yamaha CDC-675 - Manual (Page 18)

18
1
Stop the unit.
2
Select the disc.
3
The peak level searching function of this unit is useful for
adjusting recording level on the tape deck. (Refer to page 21.)
4
Enter the tape’s total possible recording time (tape length).
You can select any of four tape lengths by pressing the
TAPE button.
You can also enter the tape’s total possible recording
time manually.
Example: For a C-64 tape (32 minutes on each side)
5
Press the REPEAT button.
The unit automatically programs tracks for side A and
side B separately considering the tape’s total time.
* The programmed track numbers and the total number
of tracks for side A and B are displayed for a short
time.
6
Begin recording on the tape deck and press the PLAY
button on this unit’s remote control transmitter at the
same time.
7
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and, at
the same time, press the PLAY or PAUSE button on
this unit’s remote control transmitter.
Notes
● It is recommended that you use a tape that is slightly longer
in length than the CD you are recording, because the
programmed tracks on a CD may not fit properly into the
time allowed on each half of the tape.
● CD synchronized recording function can be used if your tape
deck is compatible with it. In this case, in step 6 and 7, press
the SYNCHRO button and then press the PLAY button on
this unit’s remote control transmitter. Recording automatically
begins. (For details, refer to page 17.)
Display information during programming
➀
Shows the number of programmed tracks for each side in
turn just after the automatic programming is finished, and
then it is replaced by the number of the first programmed
track for side A.
➁
Shows the total time of programmed tracks for each side.
➂
Shows the programmed track numbers for each side.
PROG 1 2 3 4 5
➀ ➁
➂
4
TRACK PROGRAMMING FOR RECORDING TO TAPE
for CDC-655 only for CDC-675 only
This convenient feature can be used to program tracks for
recording to tape. By only memorizing the tape’s total possible
recording time, the unit will automatically program tracks or
help you to program tracks so they will fit onto the tape with the
least amount of unrecorded space remaining at each end of
the tape.
■ Automatic tape programming
The unit will automatically program tracks on a disc with the
original order of tracks unchanged.
STOP
6
➁ ➀
TAPE
REPEAT
DISC SKIP
(off)
TAPE
2 1
TAPE
SYNCHRO
3 INDEX
PROG CLEAR
8 7 9 0
5 4 6 + I0
DIMMER OPEN/ CLOSE TEXT/ TIME
REPEAT RANDOM MODE DISC SCAN
SEARCH
SKIP OUTPUT LEVEL – +
STOP PAUSE PLAY
DISC SKIP
2
4
6, 7
7
5
1
4