ZyXEL Communications ZyXEL ZyWALL 35 - Manual (Page 399)

ZyWALL 35 User’s Guide
Chapter 24 Maintenance 397
Figure 207 Password Setup
The following table describes the labels in this screen.
24.4 Pre-defined NTP Time Servers List
The ZyWALL uses the following pre-defined list of NTP time servers if you do not specify a
time server or it cannot synchronize with the time server you specified.
When the ZyWALL uses the pre-defined list of NTP time servers, it randomly selects one
server and tries to synchronize with it. If the synchronization fails, then the ZyWALL goes
through the rest of the list in order from the first one tried until either it is successful or all the
pre-defined NTP time servers have been tried.
Table 140 Password Setup
LABEL DESCRIPTION
Old Password Type the default password or the existing password you use to access the system
in this field.
New Password Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays a (*) for each character you type.
Retype to Confirm Type the new password again for confirmation.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Note: The ZyWALL can use this pre-defined list of time servers
regardless of the Time Protocol you select.
Table 141 Default Time Servers
ntp1.cs.wisc.edu
ntp1.gbg.netnod.se
ntp2.cs.wisc.edu
tock.usno.navy.mil