A zgl menu conversions, Zgl menu conversions – Zebra Technologies SL5000r/T5000r User Manual

Page 37

Advertising

ZGL Menu Conversions

When substituting a Zebra Xi III model printer with a SL5000r/T5000r printer,
refer to the ZGL conversion table below.

Table 2: ZGL Menu

Zebra

Xi lll Series

SL5000r/T5000r with ZGL Emulation

Darkness - (0 to +30) +10*. Darkness of
image on label.

QUICK SETUP Menu,
Print Intensity

- (-15 to +15) -3*

Tear Off - (-120 to +120) +0*. Adjusts Tear
Off, Peel-Off and Cut position in Dot Rows.

QUICK SETUP Menu,
Paper Feed Shift - (-0.50 to+12.8) 0.00 Inch*. Adjusts
Tear Off, Tear-Off Strip, Peel-Off & Cut position in Inches
or MM.

Print Mode –

Rewind
Tear-Off
Peel-Off
Cutter

Applicator

QUICK SETUP Menu,
Media Handling -
Continuous (same as Zebra Rewind)
Tear-Off Strip* (same as Zebra Tear-Off)
Peel-Off (same as Zebra Peel-Off)
Cut (same as Zebra Cutter)
Tear-Off (similar to Zebra Peel-Off)
N/A Applicator N/A on SL5000r/T5000r

Media Type - Continuous*, Non-Continu-
ous.

Sensor Type -
Web - Liner gap, notch or hole. NOTE: Media
Type must = Non-Continuous.

Mark - Black mark on underside of label
(Media Type must = Non-Continuous).

QUICK SETUP Menu,
Gap/Mark Sensor-
Disable*- Same as Zebra Continuous Media Type (no
label length indicators).
Non-Continuous N/A. Assumed when Gap, Adv Gap or
Adv Notch selected.
NOTE: Use Gap, Adv Gap or Adv Notch for Zebra Web.
NOTE: No Media Type setting is available or required.
Gap - Liner gap, notch or hole.
Adv Gap - Use w/dark background labels
Adv Notch - Use with dark background labels.
Mark - Black mark on underside of label. No Media Type
setting avail. or required.