Zebra Technologies SL5000r/T5000r User Manual

Page 39

Advertising
background image

39

Zebra

Xilll Series

SL5000r/T5000r with ZGL Emulation

Media Power Up - Media action when the
printer is powered up.
Feed* - Feeds a label to1st web.
Calibration - Recalibrates media when
printer is powered up.

Length - Determines length of label.

No Motion - Media does not move.

CALIBRATE CTRL Menu,

NOTE: SL5000r/T5000r auto feeds a blank label to 1st
web (gap) when first print job is sent.
Pwr Up Auto-Cal - (Disable*, Enable)
Disable* - No recalibrate at power-up.
Enable - Recalibrates media when printer is powered up.
MEDIA CONTROL Menu,
Set Label Length -
Manual*
- Label Length set in menu.
Automatic - Auto Calibrate Sensed Distance value used
to set Label Length.
N/A

Head Close - Media action after the print-
head is closed.
Feed* - Feeds a label to1st web.

Calibration - Recalibrates media.
Length - Determines length of label.
No Motion - Media does not move.

N/A (No menu option available).
NOTE: After printhead is closed, SL5000r/T5000r auto
feeds a blank label to first web (gap) when first print job is
sent.
N/A
N/A
N/A

Backfeed - (Default*, after, before, 10 to
90%, off). Establishes when & how much
label backfeed occurs after a label is cut or
peeled-off.

N/A Distance back to TOF position of label under
printhead is auto controlled by SL5000r/T5000r
regardless of Paper Feed Shift value when using; Cut,
Tear-Off, Tear-Off Strip & Peel-Off Media Handling
modes.

Label Top - (-120 to +120 dot rows) +00*.
Adjusts vertical print position on label.

QUICK SETUP Menu,
Ver Image
Shift - (-1 to+12.8”) 0.0*”. Adjusts vertical print
position on label.

Or

PPI/ZGL SETUP Menu,
Top Position -
(-100 to +100 dots/inch)
0 dots/inch*. Adj vert. position in dot/in.
NOTE: Only avail. in later version SW.

Left Position - (-9999 to +9999)
0000*. Adjusts image horizontally from left
edge of label in dots.
(+) shifts image left. (-) shifts to right.

QUICK SETUP Menu,
Hor Image Shift -
(-1.0 to +1.0) 0.0”*.
Adjusts image horizontally from left edge of label in
inches.
(+) shifts image left. (-) shifts image right.

Or

PPI/ZGL SETUP Menu,
Left Position -
(-1000 to +1000 dots) 0 dots*. Adjusts
image horiz. in dots.
NOTE: Only avail. in later version SW.

Head Test Count- (0000*-9999) 0000
disables test.

DIAGNOSTIC Menu,
Ptr Media Dist
- Inches*, MM.

Table 2: ZGL Menu (continued)

Advertising