Yamaha Magicstomp BASS EFFECTS PROCESSOR - Manual (Page 16)

16
Create your own sound
e
Use the +/– switches to select the parameter setting display.
Parameters for the currently selected patch are arranged on several pages. Use the “+” or “–”
switches to view the next or previous page on the display.
* For more information on individual parameters, refer to the separate “Effect List” sheet.
ÿEDIT-PRM:03/10Ÿ
؇EQ1QfiEQ2FáEQ2G
Parameter
Use the knobs located below
the display to make settings
Deep Edit Icon
This icon indicates a previous page exists
Use the “–” switch to view the previous page This icon indicates a following page exists
Use the “+” switch to view the next page
Parameter Setting Display Page
Shown is page 3 of 7
ÿEDIT-PRM:03/10Ÿ
؇
0 8.2fiEQ2FáEQ2G
Parameter value
ÿEDIT-PRM:02/10Ÿ
؇TONEfiEQ1FáEQ1G ÿEDIT-PRM:04/10Ÿ
؇EQ2QfiEQ3FáEQ3G
Previous page Next page
r
Rotate the knobs to edit their corresponding parameters.
After viewing the parameters you want to edit, use the knobs located below the display to edit
the parameters. If the knob’s position does not match the parameter’s value, you’ll need to
rotate the knob until it matches the position that corresponds to the parameter value before you
can change the setting (
→ page 14).