Yamaha GX-90VCD - Manual (Page 51)

E-41
English
General information
•
When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
•
The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
•
Adjusting the VOLUME control has no effect on the
recorded sound.
If, however, the built-in graphic equalizer and/or sound
field processor is used, its effect is recorded along with
the source.
* Music with an equalizer effect is suitable for listening to
inside a car etc.
•
For the tape deck, the deck which can be used for
recording is deck 2 only. When recording, be sure to load
a tape into the deck 2 cassette compartment.
Recording from the built-in tuner
1
Press the INPUT selector or button once or more
so that “TUNER” appears on the display.
2
Tune to the desired station. (Refer to the “TUNING
OPERATION” on page 28 and 29.)
3
Load a tape into the deck 2 cassette compartment.
4
When recording with the Dolby NR system, press the
DOLBY NR button so that “
B” lights up on the display.
If not, turn it off.
*
For details, refer to the “Dolby B Type Noise
Reduction” on page 31.
5
Select the reverse mode “ ” to record on only one
side, or “ ” for
continuous recording on both sides by pressing the
reverse MODE selector button.
6
Press the REC/PAUSE button.
*
“REC” lights up on the display.
7
Press the play button on the remote control transmitter
to record on side A, or the play button to record on
side B.
*
For continuous recording on both sides, begin on side
A. Recording stops automatically at the end of side B.
To stop recording temporarily
1 1
Press the REC/PAUSE button.
2 2
To resume recording, press the play button.
To stop recording
Press the stop button.
To reduce beats during recording
While recording an AM (long wave) broadcast, you may hear
a bleep caused by beat frequencies. In such a case, pressing
the TUNER input selector button on the remote control
transmitter once or more will reduce or remove beats.
(Whenever the TUNER input selector button is pressed,
“B.C–1” and “B.C–2” appears on the display alternately.
Select either of them in which you find that beats are more
reduced.)
OTHER RECORDINGS
1 PLAYBACK 2 REC /PLAYBACK
EJECT
OPEN/CLOSE
DISC CHANGE MINI COMPONENT SYSTEM
GX–90VCD
1
2
3 DISC
PROGRAM
USER
VOLUME
MEMORY
REC/PAUSE MODE
HOUR MIN
NORMAL
DUBBING
HIGH
MEMORY
TIME ADJ
DOLBY NR
AUTO/MAN’L
TIMER
TIMER REC
MUSIC
POWER PHONES
A/B/C/D/E
RANDOM
REPEAT
EDIT
DISPLAY
CD
INPUT INPUT
TAPE 1/2
EJECT
Active Servo Technology MIC MIXING
PRESET/TUNING/BAND
VIDEO CD
Version 2.0 / Playback Control
ECHO ECHO
1
4 5 6, 1 1 3
1
1
2
2
3
3
4
4
5
5
TIME
A
DISC SKIP
PROG
B
TAPE
C
EDIT
D
+ I0
E
OPEN/CLOSE INDEX MODE
6
6
7
7
8
8
9 0
CD
PRESET
TUNER
TAPE
RETURN
STOP PLAY PLAY REC/PAUSE TAPE 1/2
MUSIC
TEST FLAT CENTER/REAR
/DELAY
PROGRAM USER
POWER
INPUT SLEEP
VOLUME
REPEAT
PREV NEXT SELECT
ECHO/KEY
LEVEL
7, 2 2
6, 1 1
1