Yamaha RX-N600 - Manual (Page 31)

27
En
CONNECTIONS
PREP
ARA
TION
If you are to use 6 ohm speakers, set “SP IMP.” to
“6
Ω
MIN” as follows BEFORE using this unit. 4
ohm speakers can be also used as the front
speakers.
1
Make sure this unit is turned off.
See page 28 for details about turning on or off this
unit.
2
Press and hold STRAIGHT (EFFECT) on the
front panel and then press MASTER ON/OFF
inward to the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Rotate the PROGRAM selector on the front
panel to select “SP IMP.”.
The following display appears in the front panel
display.
4
Press STRAIGHT (EFFECT) on the front
panel repeatedly to select “6
Ω
MIN”.
The following display appears in the front panel
display.
5
Press MASTER ON/OFF on the front panel to
release it outward to the OFF position to save
the new setting and turn off this unit.
The setting you made is reflected next time you turn on this unit.
Setting the speaker impedance
CAUTION
ZONE 2
ON/OFF ZONE CONTROL
DISPLAY CATEGORY
NEXT
SEARCH MODE
EFFECT
MEMORY MAN'L/AUTO FM FM/AM PRESET/TUNING EDIT A/B/C/D/E
PROGRAM
l PRESET/TUNING/CH h TUNING MODE AUTO/MAN'L
INPUT MODE TONE CONTROL STRAIGHT SPEAKERS PHONES
ON/OFF
MAIN ZONE
MASTER
SILENT CINEMA
B A MULTI CH INPUT
VOLUME
INPUT
ON OFF
VIDEO L AUDIO R USB VIDEO AUX
3 2,4
2,5
LEVEL
(U.S.A. model)
EFFECT
STRAIGHT MASTER
ON OFF
While holding
down
PROGRAM
S P I M P . - 8 M I N
Note
EFFECT
STRAIGHT
S P I M P . - 6 M I N
MASTER
ON OFF