Yamaha CD Recordable/Rewritable Drive CRW2200 - Manual (Page 16)

Front and Rear of Unit
8
The CRW2200E drive’s rear panel features the following:
➀ ➀ ➀ ➀ DIGITAL AUDIO OUT connector
If your sound card has a SPDIF (digital audio) input connector, you can connect the
DIGITAL AUDIO OUT connector of the unit to the SPDIF connector using a digital audio
cable (sold separately).(→P. 22)
➁ ➁ ➁ ➁ ANALOG AUDIO OUT connector
Connect one end of the 4-pin audio cable to this and the other end to your computer’s
sound card or built-in audio. (→P. 21)
➂ ➂ ➂ ➂ Jumper switch
Plug a plastic shunt into this jumper switch to select the connection, either IDE master or
slave. The CRW2200E drive’s factory setting is SLAVE. (→P. 17)
➃ ➃ ➃ ➃ IDE INTERFACE CONNECTOR
Insert the connector of the IDE cable here. Make sure you align the red line of the ribbon cable
with pin 1 of the drive’s connector, marked “IDE INTERFACE CONNECTOR 1.” (→P. 20)
➄ ➄ ➄ ➄ DC INPUT connector
Insert the power connector from your computer’s power supply in this socket to feed power
to the drive. (→P. 23)
Rear Panel
➁ ➀ ➂ ➃ ➄