Zenoah G3800AVS - Manual (Page 12)

❲ 12 ❳
■ STARTING ENGINE
1. Fill fuel and chain oil tanks respectively, and
tighten the caps securely. (F7)
2. Put the switch to "I" position. (F8)
(1) Chain oil
(2) Fuel
(3) Switch
(4) Throttle lever
(5) Throttle interlock
3. Pull out the choke knob to the second-stage
position. The choke will close and the throttle
lever will then be set in the starting position
[F10-(a)].
(6) Choke knob
When restarting immediately after stopping the
engin, Choke knob in the first-stage position (choke
open and throttle lever in the starting position)
Once the choke knob has been pulled out, it will
not return to the operating position even if you
press down on it with your finger. When you wish
to return the choke knob to the operating position,
pull out the throttle lever instead.
4. While holding the saw unit securely on the
ground, pull the starter rope vigorously. (F11)
Do not start the engine while hanging the chain
saw with a hand. The saw chain may touch
your body. It's very dangerous.
5. When engine has ignited first, puch in the choke
knob to the first-stage position and pull the
starter again to start the engine.
6. Allow the engine to warm up with the throttle
lever pulled slightly.
WARNING
NOTE
NOTE
7. Operation
F7
F8
F9
F10
F11