Zebra Technologies RW SERIES - Manual (Page 11)

11
RW Series User Guide
Getting Ready to Print
Battery Safety
The Battery Packs used on Zebra Mobile Printers contain a
great deal of energy and can cause personal injury or start a
fire if used improperly or carelessly. Please observe the fol-
lowing safety practices:
Caution • Avoid accidental short circuiting of any battery. Allowing
battery terminals to contact conductive material will create a short
circuit which could cause burns and other injuries or could start a fire.
Caution • Batteries can explode or catch fire if improperly charged
or exposed to high temperatures or fire. Do not disassemble, crush or
expose batteries to water.
Caution • Use of any charger not approved specifically by Zebra for use
with its batteries could cause damage to the battery pack or the printer
and will void the warranty.
Read carefully and always observe the safety guidelines for Li-Ion
batteries provided with each Battery Pack.
Charger Safety
Do not place the LI72-4 Quad Charger in locations where liquids or
metallic objects may be dropped into the charging bays.
Use care in locating either the LI 72 Single Charger or the LI 72-4 Quad
Charger. Do not block the ventilating slots on the top and bottom
covers. Ensure that the Charger is plugged into a power source
which won’t accidently be turned off if you will be charging batteries
overnight.
Required Regulatory Text for Argentina
Only certified adaptors with the following electrical characteristics
shall be used. The use of different adaptors could damage the device,
present hazards to the user and declare the correspondent guaranty
void.
LI 72: Input ratings: 100-240 VAC 50/60Hz 200mA., Class 2
Output ratings: 8.4 VDC, 800 mA