ZyXEL Communications 2864I - Manual (Page 25)

12 Before You Begin
•
System Name - This is the name given to the Prestige for
identification purposes. This name should be no more than 8
alphanumeric characters. Spaces are not allowed, but “-” and
“_” are accepted. This name can be obtained remotely via the
SNMP management protocol and will be displayed as the
prompt when the user enters the Command Mode.
•
Route IP Field - For Internet access, you will need to enable
the Route IP Field. See Chapter 4 for more details on
configuring your Prestige for Internet access. To support Novell
IPX, or Bridging, enable the appropriate protocol and reference
the related chapters for detailed information.
You have now collected all of the general setup information you
need. Make sure that you have entered all the values onto the
worksheet before proceeding to the next section.
Collecting ISDN Phone Line Information
After you have successfully installed the ISDN phone line or if you
already have one installed, you need to use the ISDN line
information to complete the worksheet and configure your
Prestige. Your telephone company can give you the following
information to configure the Prestige:
Switch Type Geography No of Phone #s No of SPIDs
AT&T 5ESS NI-1 North America 2 2
AT&T 5ESS Point to Point North America 1 0
AT&T 5ESS Multipoint North America 2 2
Northern Telecom NI-1 North America 2 2
Northern Telecom Custom North America 2 2
DSS1 Europe, Asia 2 N/A
1TR6 Germany 2 N/A
•
Switch Type - This is the type of switch used by your
telephone company. Check with your telephone company and
choose the appropriate option on the worksheet. For North