Yamaha RX-V430RDS - Manual (Page 23)

21
English
INTR
ODUCTION
PREP
ARA
TION
B
ASIC OPERA-
TION
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
This section explains how to adjust speaker output levels
using the test tone generator. When this adjustment is
complete, the output level heard at the listening position
should be the same from each speaker. This is important
for best performance of the digital sound field processor,
and the various decoders (Dolby Digital, Dolby Pro
Logic, Dolby Pro Logic and DTS).
Note
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from
the PHONES jack when using the test tone.
Using the test tone
Use the test tone to balance the output levels of the
speakers. The adjustment of each speaker output level
should be made at your listening position using the
remote control.
1 Press TEST to output the
test tone. TEST
BASS
– +
TREBLE
– +
SET MENU LEVEL
DSP
+ –
STEREO
EFFECT
MUTE
VOLUME
TEST
1,4
3
2
ADJUSTING SPEAKER OUTPUT LEVELS
NATURAL SOUND AV RECEIVER
SILENT
PHONES
STEREO
EFFECT
PROGRAM PRESET/TUNING A/B/C/D/E
BASS
– + – +
TREBLE
INPUT
INPUT M0DE 6CH INPUT
VOLUME
STANDBY /ON
MEMORY FM/AM
EDIT
PRESET/TUNING
MAN'L/AUTO FM AUTO/MAN'L MONO
TUNING MODE
2
2
VOLUME
VOLUME
Remote control
Front panel
or
2 Set the BASS and TREBLE controls on the
front panel to the center position and adjust
the volume of this unit so you can hear the
test tone.
The test tone is heard (in order) from the main left
speaker, center speaker, main right speaker, rear right
speaker, rear left speaker, and the subwoofer. The
tone is produced for 2.5 seconds from each speaker.
* Subwoofer test tone is output after the rear left
speaker (LEFT SURROUND).
The front panel display shows which speaker is
outputting the test tone.
Note
• If the test tone cannot be heard, turn down the volume, set this
unit to standby mode and check the speaker connections.
L SUR. R SUR.
CENTER
RIGHT LEFT
* SUBWOOFER
0104V430_20-22_EN(GB) 1/19/02, 8:03 PM 21