Yamaha RX-V430RDS - Manual (Page 49)

47
English
INTR
ODUCTION
PREP
ARA
TION
B
ASIC OPERA-
TION
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
You can adjust the output level of each effect speaker
(center, rear left and right, and subwoofer) while listening
to a source.
Adjustment should be made with the remote control.
(While playing a source)
1 Press LEVEL repeatedly to select the
speaker(s) you want to adjust.
Each time you press LEVEL, the selected speaker
changes and appears on the front panel display as
follows: center, rear right, rear left and subwoofer.
LEVEL
SET MENU LEVEL
DSP
+ –
STEREO
EFFECT
MUTE
VOLUME
TEST
1
2
1
DSP
+ –
DSP
+ –
LEVEL
ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS
y
• Once you press LEVEL, you can also select the speaker(s) to
be adjusted by pressing d / u.
Center speaker output level
Subwoofer output level
Rear left speaker output
level
Rear right speaker output
level
2 Press +/– to adjust the speaker output level.
• The control range for the center or rear left and
right speakers is from +10 dB to –10 dB.
• The control range for the subwoofer is from 0 dB
to –20 dB.
Notes
• When the speaker output modes for “1A CENTER” and “1C
REAR LR” are set to NON, and “1D BASS” to MAIN, the
output level of those speakers cannot be adjusted because there
is no sound coming from these speakers.
• When you adjust the output level with LEVEL, the settings you
made with the test tone will be changed.
• We recommend adjusting the speakers by following the steps
described in “Using the test tone” on pages 21 and 22.
■ For 5ch Stereo
You can adjust the volume level for each channel in 5-
channel stereo mode.
Control range: 0 to 100%
• CT level (Center level)
• RL level (Rear left level)
• RR level (Rear right level)
1 Select 5ch Stereo.
2 Press u / d repeatedly to select the
speaker(s) you want to adjust.
3 Press +/– to adjust the speaker output level.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby
mode. However, if the power cord is disconnected
from the AC outlet, or the power supply is cut for
more than one week, the stored data will be lost. If so,
set the output level again.
0109V430_47-49_EN(GB) 1/19/02, 8:05 PM 47