Zephyr GU5/MR16 - Manual (Page 11)

- 11 -
5.3 d
elay
o
ff indicator
(7)
- Delay Off Indicator will light up when Delay Off Function is activated by pressing the Delay Off
Button.
- Delay Off Indicator will turn off after the Delay Off Function has completed the five minute
cycle or if the user presses the Delay Off Button again or the Power Button.
delay off timer enabled and fan speed changed to 1
5.4 c
lean
a
ir indicator
(8)
- Clean Air Indicator is disabled by default and must be enabled by the user.
- To enable Clean Air Function:
With hood off, hold the Power Button down for five seconds. Clean Air Indicator light will illumi-
nate, and the fan will turn on low speed for 10 minutes. After 10 minutes the fan will turn off and
the 4 hour timer will begin.
Clean Air Indicator will remain on when Clean Air Function is enabled, even if fan is not on.
- When Clean Air Function is enabled, every four hours of non fan usage the fan will automatically
turn on at low speed for 10 minutes. After 10 minutes the fan will turn off and the 4 hour timer
will reset.
- When the Clean Air Function automatically turns the fan on the Clean Air Indicator will blink and
the Low Speed fan indicator will illuminate.
- If the user changes the fan speed while the Clean Air Function is operating, the Clean Air Indicator
will stop blinking but will remain illuminated. When the user manually turns the hood off the 4
hour timer will reset.
- To disable Clean Air Function:
With hood off, hold Power Button down for five seconds until Clean Air Indicator light turns off.
Note1: Changing the fan speed and interrupting the Clean Air Function while it is operating does
not disable the Clean Air Function. Clean Air Function will only be disabled by holding the Power
Button for 5 seconds
Note2: Turning lights on/off does not disable the Clean Air Function
clean air function enabled with low fan speed turned on by clean air function
5.
D
ispla
y
O
ptions
www.zephyronline.com