Zephyr GU5/MR16 - Manual (Page 14)

- 14 -
6.2 r
eplacinG the liGht bulb
:
WARNING
Disconnect the hood from electricity and be sure the lights are cool.
If new lights do not operate, make sure the light bulb is inserted correctly before calling service.
For bulb type GU4/MR11 12V 20W; hood models ALA, ALL, APN, ASU and ASL
For bulb type GU5/MR16 12V 20W; hood models AHZ and ATI
- Using a small flat head screwdriver or equivalent tool, carefully pry loose the light bulb to discon-
nect it from the spring clamps in the socket. Take care not to scratch the bottom of the hood.
- Pull down on bulb to remove.
- Check proper orientation of bulb to socket before inserting new bulb. Push upwards until bulb
engages into socket and spring clamps. Replacement bulb must have a safety heat fused lens “sui-
table for use in open luminaries”.
For bulb type G4 12V 20W; hood models ADU, ADL, and AED
- Using a small flat head screwdriver or equivalent tool, carefully pry loose the light cover. Take care
not to scratch the bottom of the hood.
- Remove the defective light bulb and replace with a new light bulb, “suitable for use in open lumina-
ries”. Follow package directions and do not touch new light bulb with bare hands.
- Reinstall the light cover.
light bulb
6.
Main
tenanc
e
www.zephyronline.com