Before you start – Xerox 50 LP/ST User Manual
Page 82
5-2
AppleTalk Network Installation
Before You Start
1
CentreWare Internet Services network software provided with the copier/
printer will be used during this procedure to customize the printer network
connectivity settings. The printer supports the AppleTalk Phase 2
protocol.
2
Make certain that your printer is properly connected to the network with
the appropriate cabling. See Chapter 1 Network Printer Features for
detailed information on making the physical connections needed to install
the printer on your network.
3
Obtain a Configuration Report (printed approximately 5 minutes after
every printer power off and on sequence, if this feature has not been
disabled) to verify that AppleTalk is enabled, and to view other current
settings on the copier/printer. If AppleTalk is not enabled, see Step 1
Customizing Printer Connectivity Settings for information on enabling
AppleTalk.
4
Ensure that you have a Macintosh installer program. This is used to install
the printer driver software.
5
Ensure you have a browser (version 4.0 or higher) on your Macintosh in
order to use Internet Services. Internet Services can be used to review and
change connectivity settings.