Cdx-393, English – Yamaha CDX-393 User Manual

Page 5

Advertising
background image

5

English

CDX-393

LINE OUT

CD

1

CDX-393

To AC outlet

1

Connection cord
(included)

Amplifier

To connect this unit to your amplifier, choose one of the following procedures:

1

When the LINE OUT (analog) terminals of
this unit are used

• Be sure that the left (“L”) and right (“R”) LINE OUT

terminals are connected to the corresponding (left and
right) terminals of the amplifier or other component.

• Connect the “LINE OUT” terminals to the “CD” (or “AUX”)

terminals of the amplifier. If the amplifier does not have
such terminals, use the “TAPE PB” terminals. For
additional details concerning these connections, refer to
the operation instructions for the amplifier being used.

• The LINE OUT terminals of this unit are numbered

1

.

When connecting this unit with a YAMAHA amplifier or
receiver whose terminals on the rear panel are
numbered as

1

,

2

,

3

, etc., connect the LINE OUT

terminals of this unit to the input terminals numbered

1

on the rear of the amplifier or receiver.

2

CDX-593 and CDX-493 only

When the DIGITAL OUT (OPTICAL) terminal
of this unit is used

• Before using this terminal, remove the terminal’s cover.
• Make the connection from this terminal to the optical

input terminal of an amplifier by using a commercially
available optical fiber cable.
* Use an optical fiber cable that conforms to EIAJ

standards. Other cables might not function correctly.

• Be sure to replace the terminal’s cover when this

terminal is not being used, in order to protect the
terminal from dust.

• The signal output level to an amplifier can be adjusted by

using the OUTPUT LEVEL button.

• This terminal can also be connected to the optical input

terminal of a digital audio tape deck (DAT) etc. to record
CD onto a tape directly.

3

CDX-593 only

When the DIGITAL OUT (COAXIAL) terminal
of this unit is used

• Make the connection from this terminal to the digital

input terminal of an amplifier by using a connection cord.

• The signal output level to an amplifier can be adjusted by

using the OUTPUT LEVEL button.

Advertising
This manual is related to the following products: