Zenoah EXZ2600DL - Manual (Page 10)

GB-10
EXZ2600DL
MOUNTING ENGINE
1. Push the drive shaft housing toward the clutch hous-
ing and rotate it by hand to check that the drive shaft
is engaged with the gears.
2. Insert the drive shaft housing into the clutch housing
until it bottoms, and align the positioning holes on the
clutch housing and the shaft tube and install the screw.
When difficult to engage, twist the engine slightly.
3. Fasten the clamp securely with two screws.
IMPORTANT
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
CONNECTING SWITCH WIRES
• Connect the switch wires between the engine and the
main unit. Pair the wires of the same color.
INSTALLING HANDLE
(BC-EX, LRT-EX only)
• Install the handle to the shaft tube and clamp it at a
location that is comfortable to you.
6. Set up
(PS-EX only)
• Insert the grip to the shaft tube.
• Fasten the clamps with screws.
(HE-EX only)
• Install the J-shaped handle to the shaft tube and clamp
at a position best for your job.
JOINT ATTACHMENT
• Insert the attachment to the main shaft.
• Tighten the knob bolt securely.
Knob bolt
About 19 inches (48 cm)