Zenoah EXZ2600DL - Manual (Page 11)

GB-11
G
B
EXZ2600DL
6. Set up
(BC-EX only)
INSTALLING DEBRIS GUARD
• Put the debris guard on the gearbox, attach it with
the 4 screws and hardware provided.
(1) Debris guard
(2) Plate
(3) Screw
INSTALLING CUTTING HEAD
1. While locking the gear shaft, by inserting the supplied
tool into the upper holder on the gearbox, loosen and
remove the hexagon nut (left-handed).
2. Then screw in the cutting head to the gear shaft over
the holders. Hand-tighten it securely.
BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with head
just touching on the ground.
6. Set up
(LRT-EX only)
ATTACHING THE TRIMMING MECHANISM
(1) Main pipe
(2) Trimming mechanism
(3) Screw hole
(4) Screw
(5) Fastening bolt
1. Remove the screw screwed into the end of the trim-
ming mechanism.
2. Insert the end of the trimming mechanism into the main
pipe.
3. Line up the hole on the end of the trimming mecha-
nism into which the screw is to be inserted with the
hole on the main pipe, and screw the screw firmly in.
4. Using a wrench, screw in the bolt provided to fix the
trimming mechanism into place.
BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture, slide clamp up or
down until unit balances and the strap fits your body.
(1)
(2)
(3)