Xerox 92C IPS - Manual (Page 18)

CLEARING PAPER MISFEEDS AND JAMS
2-4 XEROX DOCUPRINT 92C IPS TROUBLESHOOTING GUIDE
Frequent misfeeds
Frequent misfeeds may be caused by a glazed feed belt, especially
if one tray feeds the same kind of paper better than another tray
does. (Glazing is caused by a buildup of the chemicals found on most
papers.)
If you suspect that the belt is glazed, try cleaning it with film remover
obtained from your service representative.
Caution: Clean the feed belt only to correct misfeeds, not as
routine maintenance. Because the belt is rubber, frequent cleaning
dries it out and makes it fail prematurely.
1. Clear any misfeeds that have occurred, but do not latch the
paper feeder assembly. If necessary, unlatch it by pressing
down on the bright green lever on the right side of the paper
tray.