Xerox 92C IPS - Manual (Page 39)

CLEARING PAPER MISFEEDS AND JAMS
XEROX DOCUPRINT 92C IPS TROUBLESHOOTING GUIDE 2-25
Adjusting dual stacker tray scuffer arms
Paper jams can occur when the paper does not stack smoothly in the
dual stacker trays. If some papers stack well while others do not, the
weights under the scuffer arms may need to be adjusted.
Note: The scuffer arm weights on some printers are bolted in place.
These must be adjusted by a service representative.
The adjustable weights are located on the underside of the scuffer
arms, on a track down the center. To adjust them:
1. Slide the weight right or left along its track under the scuffer
arm.
•
If the paper is driven too far up the outside edge of the tray,
move the weight toward the machine.
• If the paper is not driven far enough into the tray, move the
weight away from the machine.
Note: For lightweight paper, move the weight toward the
machine; for heavyweight paper move the weight away
from the machine.
Figure 2-6. Adjusting scuffer arm weights
1 Scuffer arm
2. Clear all paper jams, following the jam clearance instructions
provided by the message and graphic displays on the printer
control console.
3. Discard any pages sent to the sample tray or to a stacker tray
when the jam was detected.
4. Press the Continue button on the printer control console to
resume printing.
1