Basic operations, When you finish using this unit, Set to the – Yamaha RX-496RDS User Manual
Page 14: Position, Turn the power on, Adjust to the desired output level, Aon b off, Man’l/auto fm, Auto/man’l mono
14
1
Set to the “
∞
” position.
2
Turn the power on.
3
Select the desired input source by using the input
selector buttons.
* The name of the selected input source will appear on
the display.
4
Select the speakers to be used.
* If you use two speaker systems, press both the A and B
switches.
5
Play the source. (For detailed information on the
tuning operation, refer to page 17.)
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE and
LOUDNESS controls, or use the PURE DIRECT switch
(for RX-496RDS and RX-496 only). For details, refer to
page 16.
Notes on using the input selector buttons
●
Note that pressing each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
●
The selection of TAPE 2 MONITOR cannot be canceled by
pressing another input selector button. To cancel it, press
TAPE 2 MONITOR again so that the “TAPE MON 2”
indicator disappears from the display.
When you select a button other than TAPE 2 MONITOR,
make sure that the “TAPE MON 2” indicator is not
illuminated on the display.
When you finish using this unit
Press the STANDBY/ON switch on the front panel again or
the STANDBY/ON key on the remote control transmitter to
turn this unit into the standby mode.
BASIC OPERATIONS
TO PLAY A SOURCE
l6
20
28
40
60
l2
8
4
2
0
–dB
VOLUME
SPEAKERS
A
ON
OFF
B
l6
20
28
40
60
l2
8
4
2
0
–dB
VOLUME
TUNER
CD
PHONO
AUX
TAPE 1/MD
TAPE 2
MONITOR
STANDBY/ON
7
2
4
7
STANDBY/ON
NATURAL SOUND STEREO RECEIVER
SPEAKERS
PHONES
A
ON
B
OFF
BASS
TREBLE BALANCE
VOLUME
PURE DIRECT
5
5
4
3
2
l
0
l
2
3
4
5
5
4
3
2
l
0
l
2
3
4
L
R
l6
20
28
40
60
l2
8
4
2
0
–dB
5
5
4
3
2
l
0
l
2
3
4
FM/AM
MAN’L/AUTO FM
TUNING
MODE
AUTO/MAN’L MONO
DOWN TUNING UP
MEMORY
EDIT
A/B/C/D/E
1
2
3
4
5
6
7
8
TUNER
CD
PHONO
AUX
TAPE 1/MD
TAPE 2
MONITOR
LOUDNESS
5
6
7
4
3
2
l
FLAT
l0
–30dB
9
8
3
From page 14 to 25, this manual describes how to operate this unit mainly by using the front panel control parts.
To operate this unit on the remote control transmitter, use the corresponding keys on the remote control transmitter.
1, 6
: RX-496RDS and RX-496 only