Yamaha RX-496RDS - Manual (Page 17)

17
English
1
Select “TUNER” as the input source.
2
Select the reception band (FM or AM) confirming it on
the display.
3
4
To tune to a higher frequency, press the right side once.
To tune to a lower frequency, press the left side once.
* If the station where tuning search stops is not the desired
one, press again.
* If the tuning search does not stop at the desired station
(because the signals of the station are weak), change to
the MANUAL TUNING method.
1
Select “TUNER” as the input source.
2
Select the reception band (FM or AM) confirming it on
the display.
3
4
Tune to a desired station manually.
* To continue tuning search, hold down the button.
Notes
•
If you tune to an FM station manually, it is received in
monaural mode automatically to increase the signal quality.
•
When tuned in to a station, the frequency of the received
station is shown on the display. If an RDS station that
employs PS data service is received, the frequency is then
replaced by the station name. Refer to page 23 for details.
TUNING OPERATIONS
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
AUTOMATIC TUNING MANUAL TUNING
FM/AM
TUNING
MODE
AUTO/MAN’L MONO
TUNING
MODE
AUTO/MAN’L MONO
DOWN TUNING UP
DOWN TUNING UP
Turn the “AUTO”
indicator off.
2 1
STANDBY/ON
NATURAL SOUND STEREO RECEIVER
SPEAKERS PHONES
A
ON
B
OFF
BASS TREBLE BALANCE
VOLUME
5 5
4
3
2 l 0 l 2
3
4
5 5
4
3
2 l 0 l 2
3
4
L R
l6 20
28
40
60
l2
8
4
2
0 –dB
5 5
4
3
2 l 0 l 2
3
4
FM/AM
MAN’L/AUTO FM
TUNING MODE
AUTO/MAN’L MONO
DOWN TUNING UP
MEMORY EDIT
A/B/C/D/E 1 2 3 4 5 6 7 8
TUNER CD PHONO
AUX TAPE 1/MD TAPE 2 MONITOR
LOUDNESS
5 6 7
4
3
2 l FLAT
l0 –30dB
9
8
3 4
TUNER CD PHONO TUNER CD PHONO
AUTO
RX-496RDS and RX-396RDS only
or or
FM/AM