Zanussi ZCG560G - Manual (Page 13)

Removing the oven door and the glass
panel
1
Open the door
fully and hold the two
door hinges.
2
Lift and turn the
levers on the two
hinges.
3
Close the oven
door to the first open-
ing position (halfway).
Then pull forward and
remove it from its
seat.
1
1
4
Place the door on
a stable surface pro-
tected by a soft cloth.
Use a screwdriver to
remove 2 screws
from the bottom edge
of the door.
Important! Do not
lose the screws.
.
3
2 2
5
Use a spatula
made of wood or
plastic or equivalent
to open the inner
door.
Hold the outer door,
and push the inner
door against the top
edge of the door.
6
Lift the inner door.
7
Clean inner side
of the door.
Clean the glass panel
with water and soap.
Dry it carefully.
Warning! Only clean the glass panel with
water and a soap. Abrasive cleaning
agents, stain removers and sharp objects (e.g.
knives or scrapers) can cause damage to the
glass.
Inserting the door and the glass panel
When the cleaning procedure is completed, in-
sert the oven door. To do so, do the steps in
opposite way.
4
4
5
5
6
What to do if…
Problem Possible cause Remedy
The flame is blown out
immediately after igni-
tion. The thermocouple is not heated suffi-
ciently. After lightning the flame, keep the knob
pushed for approximately 10 seconds.
13
www.zanussi.com