Zanussi ZCE 7600 User Manual

Page 9

Advertising
background image

Note: Vapours from the oven vents may in time
cause discoloration of wallcoverings behind the
cooker. For ease of cleaning it may be preferable to
tile behind the cooker.

Overhanging surfaces or a cooker hood should be a
minimum of 685mm above the hob.

It is important to ensure that the cooker is level after
installation. Levelling feet are fitted to the front of the
cooker to accommodate uneven floors.

GENERAL NOTES ON USING YOUR
COOKER

Wipe over the grill compartment and fan oven base
with a soft cloth and hot soapy water and wash the
grill and oven furniture before use.
We suggest that you run the oven elements for 10 -
15 minutes at 220°C to burn off any residue from
their surfaces.
The procedure should be repeated with the grill for
approximately 5 - 10 minutes.
During this period an odour may be emitted, it is
therefore advisable to open a window for ventilation.

ABOUT CONDENSATION AND STEAM

When food is heated it produces steam similar to a
boiling kettle. The ovens are vented to allow some of
this steam to escape. However, always stand back
from the cooker when opening the oven door to allow
any build up of steam or heat to release.

If the steam comes into contact with a cool surface
on the outside of the cooker, e.g. a trim, it will
condense and produce water droplets. This is quite
normal and is not caused by a fault on the appliance.

To prevent discoloration, regularly wipe away
condensation and also soilage from surfaces
including the vent at the rear of the hob. See note
at the top of this page.

For your safety wallcoverings at the rear of the
cooker should be securely fixed to the wall.

PUSH TO TURN CONTROL KNOBS

(ZCE 7600 only)

These control knobs must be pushed in towards the
control panel before they can be turned or adjusted.

POP IN POP OUT CONTROL KNOBS

(ZCE 7800 only)

These control knobs can remain flush with the
control panel when not in use, or pushed and
released to stand out from the panel for easy
operation.

The cooling fan operates immediately when the grill
or top oven is switched on. It may run on after the
controls are switched off until the appliance has
cooled. If an automatic programme has been set the
cooling fan does not switch on until the cooktime
begins.

CONTROL PANEL INDICATOR NEONS

These lights indicate whether the ovens (model 7600
only) or ovens, hob or grill (model 7800 only) are
switched on.

In the case of the ovens, the neons also indicate
when the set temperature has been reached. They
will cycle on and off during use to show that the
temperature is being maintained.

If the neons do not operate as the instructions
indicate the controls have been incorrectly set.
Return all controls to zero and re-set following the
instructions for the required setting.

When the oven has been set for automatic cooking
the neon should remain unlit during OFF periods.

COOKWARE

Baking trays, oven dishes etc., should not be placed
directly against the grid covering the fan at the back
of the oven.

Do not use baking trays larger than 30cm x 35cm
(12" x 14") as they will restrict the circulation of heat
and may affect performance.

9

THE COOLING FAN FOR THE CONTROLS

Advertising
This manual is related to the following products: