ZyXEL Communications SP-200E - Manual (Page 3)

SP-200E User’s Start Guide
3
Table 1 Rear Panel Hardware
2.2 Rear Panel
1 Reset button
2 Power switch
3 DC power socket
4 Ethernet port (RJ-45)
5 PS/2 keypad port
Label Description
RST Press this button for 10 seconds to restore the factory default settings. The default IP
address is 192.168.1.1.
ON OFF Use this power switch to turn the printer on or off.
DC Use the printer’s included power adaptor to connect this power socket to a power supply.
POE RJ-45 port Use an Ethernet cable to connect this port to the gateway. You can use a mid-span POE
(Power Over Ethernet) injector (not included) instead of the power adaptor.
Yellow LED: 100 Mbps Link/ACT. This LED comes on when there is a 100 Mbps connection
and blinks when sending or receiving traffic.
Green LED: 10 Mbps Link/ACT, green. This LED comes on when there is a 10 Mbps
connection and blinks when sending or receiving traffic.
PS/2 keypad port Connect an optional PS/2 keypad to this port. Refer to the hotspot gateway User’s Guide for
information on how to configure the gateway for use with the SP-200E and the optional PS/
2 keypad.
1 2 3 4 5