Zebra Technologies Z6000 - Manual (Page 48)

40 Z Series™ User’s Guide
SYMPTOM DIAGNOSIS ACTION
In Peel-Off Mode,
skewed or stuck labels.
Glue material from
back of labels causing
media movement
problems.
Perform maintenance
and clean the printer.
Media and backing not
aligned in printer.
Check media guide
positions.
Labels are not being cut. Cutter Mode not
selected.
Reconfigure the printer.
The Cutter is not cutting
labels cleanly.
Cutter is dirty. Clean Cutter Blades.
Cutter Blades are dull. Replace Cutter Module.
Labels are jamming up in
the Cutter or are being
cut more than once.
Cutter is dirty. Clean Cutter Blades.
Label length too short. Increase label length.
Printing stops.
PAUSE, and
ERROR LEDs
Solid ON.
Out of media. Load media.
Out of ribbon Load ribbon
For
printers
with the
Cutter
Option
installed.
Media jammed in
the Cutter.
Remove media, clean
Cutter if necessary.
Cutter Module is dirty. Clean Cutter Module.
If error condition persists after attempting each
of the above solutions, call a Service
Technician.
Printer Self-Tests
The Z Series™ printer is designed to work with most Zebra media and
ribbon combinations, right out of the box. However, in some applica-
tions, changes to the printer’s configuration and mechanical settings
may be required. For these situations, printer self-test labels can be
used to check print quality and ins(he)-20oprinter