Zebra Technologies Z6000 User Manual
Page 49
Make sure that your print width is set correctly for the media you are
using before you run any self-tests, otherwise the test may print out on the
platen. If your media is not wide enough or long enough to display a
complete test label, unexpected and/or undesired results may occur.
When performing these self-tests while in the Peel Mode, you must
remove the labels as they become available.
CANCEL Key Self-test
Press and hold the CANCEL key while turning the printer power ON.
Release the key anytime after the first front panel LED turns OFF.
The CANCEL key self-test prints a configuration label showing:
n
Printer configuration
n
Installed options
n
Software version
n
Copyright notice
Figure 19 shows an example of the Printer Configuration Label. The
configuration information will print over several labels if a label is not
long enough to display all of the configuration information at one time.
Z Series™ User’s Guide
41
Figure 19. CANCEL Key Self-test Label
49
H:...uspiran2.vp
Thu Jun 18 16:02:06 1998
Color profile: Disabled
Composite Default screen