Yamaha GX-3 - Manual (Page 12)

E-6
Loading the batteries for the
remote control transmitter
(See figure 5 on page 5 5 .)
1
Remove the battery compartment cover.
(Slide the cover in the direction of the arrow on the cover.)
2
Insert 2 “AAA” (R03) batteries into the battery
compartment.
*
Installing the batteries improperly may cause failure.
3
Replace the battery compartment cover.
Precautions for battery use
•
Insert the batteries according to the direction indicated in
the battery compartment.
• Replace all batteries with new ones at the same time.
• Remove the batteries if they are weak or if the unit is not
in use for long periods.
• Don’t mix normal batteries with rechargeable batteries.
Proper use of the remote control
transmitter
(See figure 6 on page 5 5 .)
Aim (within the range of 60° with no obstacles) the remote
control transmitter at the remote control sensor and operate
as shown.
Notes concerning use
• Replace the batteries if control distance decreases or
operation becomes unstable.
• Periodically clean the transmitter window on the remote
control transmitter and the sensor on the main unit with a
soft cloth.
• Exposing the sensor on the main unit to strong light
(especially an inverter type of fluorescent lamp etc.) may
interfere with operation. In this case, reposition the main
unit to avoid direct lighting.
• Keep the remote control transmitter away from moisture,
excessive heat, shock and vibrations.
• The remote control transmitter’s usable range is within
0.2m (8”) and 6m (20’) away from the sensor.
REMOTE CONTROL TRANSMITTER
• Be sure that your headphones have a 3.5 mm (1/8”)
diameter plug and are between 16 ohms and 50 ohms
impedance. Recommended impedance is 32 ohms.
•
When headphones are connected, the speakers are
defeated automatically. Adjust the VOLUME control for
desired volume.
LISTENING WITH HEADPHONES
Speaker connection
(See figure 7 on page 6 6 .)
Connect each speaker wire to the SPEAKERS terminals.
Cautions
• Do not let the bare speaker wires touch each other as this
could damage the power amplifier and/or speakers.
• When connecting the speakers to the unit, be sure to
connect the speaker wires properly. Do not make a
mistake from the right channel to the left channel and from
the plus (+) terminal to the minus (–) terminal.
•
Do not connect these SPEAKERS terminals to speakers
other than the provided speaker system NX-GX3.
System connection
(See figure 8 on page 6 6 .)
• Make system connections between TCD-GX3 and KMA-
GX3 with the provided two system connector cables as
figured.
• Connect the CD terminals of TCD-GX3 and KMA-GX3
with the provided pin-plug connection cord.
CONNECTIONS
PHONES