Z Microsystems GLIDER 20 - Manual (Page 11)

Doc# 27-0006UM Issued 11/00 Rev 1.0
1 1
WARNING: Be sure all electrical
power to the cabinet is
off before connecting
any of the cables.
WARNING: There is a key guide
for alignment on the
cables. Be sure the cable
plug and receptacles are
aligned properly using
the key guide.
Misalignment can cause
short circuiting.
INSTALL CABLES
The power cable comes
out at the back of the
power supply on the
rear of the Glider tray.
Be sure the plug is
pushed all the way in.
The power supply is
mounted on the back of
the Glider tray. Be sure
the power plug going in
to the power supply is
pushed all the way in.
The power supply cable
should be connected to
a suitable 110-vac
grounded power.
The socket outlet shall be
installed near the
equipment and shall be
easily accessible.
NOTE: The glider has an AC-
DC converter built
into the power supply.
Be sure the AC supply
is 110 vac and
properly grounded.