Z Microsystems GLIDER 20 - Manual (Page 9)

Doc# 27-0006UM Issued 11/00 Rev 1.0
Install Glider
9
INSTALL THE GLIDER IN CABINET FRAME
The Glider slides should
move in and out easily.
If not, check alignment
of the slider and Z-Lock
mount.
Pull the two Glider
slides out until they
lock.
Hold the Glider on
each side over the back
set of rollers, with the
front into your stomach.
The Glider MUST be
level. This step may
best be done with two
people, one on each
side of the slide rails.
If the Glider binds
during insertion, the
Glider rollers are not
properly aligned into
the slider recepticle.
Simultaneously press in
the catches on each
slider and move the
Glider all the way into
the cabinet frame.
Feed the cables from
the Glider back through
the cabinet frame.
Guide the Glider into
the slides and slide the
Glider in until it stops.
If aligned properly, the
rollers on the Glider
slide smoothly into and
out of the slider rails.