Yamaha RX-V470 - Manual (Page 8)

8
AC OUTLETS SPEAKERS
FRONT +
A
B
A
B
– + – R L TAPE VCR
TAPE PB REC OUT TAPE PB REC OUT
AUDIO SIGNAL
+
–
R
L
SPEAKERS
CENTER REAR REAR
+
–
R L
L
R
FRONT
A
+
–
–
+
B
L
R
REAR
–
REAR
+
CENTER
ABOUT THE AC OUTLETS
U.S.A., Canada, Europe and General models:
2 SWITCHED OUTLETS
Australia and U.K. models:
1 SWITCHED OUTLET
Use these to connect the power cords from your
components to this unit.
CONNECTING SPEAKERS
Connect the SPEAKERS terminals to your speakers with
wire of the proper gauge, cut to be as short as possible. If
the connections are faulty, no sound will be heard from the
speakers. Make sure that the polarity of the speaker wires
is correct, that is, + and – markings are observed. If these
wires are reversed, the sound will be unnatural and will lack
bass. Do not let the bare speaker wires touch each other
and do not let them touch the metal parts of this unit as this
could damage this unit and/or speakers.
÷ Use speakers with the specified impedance shown on the
rear of this unit.
Notes on front speakers connections
One or two speaker systems can be connected to this unit.
If you connect only one speaker system, connect it to either
the FRONT A or B terminals.
Front speakers A
Right Left
Rear speakers
Right Left
Right Left
Front speakers B
Center speaker
How to Connect
1
Raise (or press down) the tab.
2
Insert the bare wire. [Remove approx. 5mm (1/4")
insulation from the speaker wires.]
3
Press down (or raise) the tab to secure the wire.
Rear and center speaker terminals Front speaker terminals
1
1
2
Black: Negative (–)
Red: Positive (+)
3
Red: Positive (+)
Black: Negative (–)
2
The power to the SWITCHED outlets is controlled with this
unit’s POWER switch or the provided remote-control
transmitter’s POWER key. These outlets will supply power
to any component whenever this unit is turned on.
The maximum power (total power consumption of
components) that can be connected to the SWITCHED AC
OUTLETS is 100 watts or 200 W (U.S.A. and General
models).
3