Zanussi jetstream ZJD12191 - Manual (Page 6)

1 Detergent dispenser drawer
2 Mains-on light
This light comes on when the ON/OFF button is
pressed, and goes out when it is pressed again.
3 ON/OFF button
Press this button to switch the machine on. Press it
again to switch the machine off.
Programme Option buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing the
desired programme and before depressing the START
PAUSE button.
When these buttons are pressed, the corresponding pilot
lights come on. When they are pressed again, the pilot
lights go out.
If an incorrect option is selected, the corresponding
pilot light flashes for about 2 seconds and the message
Err is displayed.
4 PREWASH button
The machine performs a prewash cycle at 30°C max.
The prewash cycle ends with a short spin at 650 r.p.m.
in programmes for C
OTTON
and S
YNTHETICS
, and with
emptying of the water for D
ELICATES
.
This option is not available with the
WOOL
programme/(handwash) and Miniprogramme .
For use when washing heavily soiled laundry.
5 SPIN SPEED button
Press this button to reduce the maximum speed of the
final speed proposed by the machine for the selected
programme or to select position
(RINSE HOLD) .
6
The Control Panel
1 2 3 4 5 9 6 7 8 1011
12
13 14
1200
900
700
500
START
PAUSE
DRYING
TIME
QUICK
WASH
DELAY
START
95º
E
60º
40º
30º
60º
40º
30º 40º
30º
X
40º
COTTON
DELICATES SYNTHETICS
WOOL
60º
SPECIAL
40ºE
60ºE
SUPER
RINSE
SPIN
SPEED PREWASH DAILY
30º
Z J D . 1 2 1 9 1
ON/OFF
The light corresponding to the selected option
illuminates.
The following speeds are available for the different
fabrics:
• C
OTTON , linen: 500/700/900 max 1200 r.p.m.
• S
YNTHETICS
and
WOOL
/(handwash) :
500/700 max 900 r.p.m.
• D
ELICATES
and
MINIPROGRAMME
:
500 max 700 r.p.m.
The light corresponding to the selected option
illuminates.
Rinse Hold
When RINSE HOLD option is selected, the last rinse
water is not emptied out, to prevent the fabrics from
creasing. When the programme has finished, the light
of the START PAUSE button and the pilot light
(DOOR) go out, the light
and the pilot light
(
END
) are alight to indicate that the water must be
emptied out.
To empty out water there are 2 possibilities:
• Select programme
(draining):
The water is emptied out without spinning.
• Select programme (spin): reduce eventually the
spin speed by means of the relevant button and then
depress the START PAUSE button.
The water is emptied out and the laundry is spun at
the selected spin speed.
Attention! Before selecting programmes (Drain) or
, the selector dial has to be positioned on X
(cancelling).
The RINSE HOLD option CANNOT be selected for
the automatic Washing & Drying programme.
6 DAILY button
This option can be used for lightly soiled cotton or
synthetic items items in order to obtain a good
washing performance in a short time.