Xerox 510DP (Operator Manual) - Manual (Page 56)

PROBLEM SOLVING
46 XEROX WIDE FORMAT 510dp OPERATOR MANUAL
Problem solving table
The table below lists some conditions that may occur during the
operation of the printer. You may be able to resolve the problems
by following the suggested solutions in the table. For problems
beyond the scope of this table, call for service.
Table 4. Problem-Solving Table
Condition Causes Suggested Solutions
Portions of the prints are deleted. The media may be damp. Check the condition of the media. If
damp, replace it.
Store the media in a sealed
package or bag.
The prints are light overall or have
light areas. The print density may be too light. Use the Printer Menu to adjust the
print density. Refer to "Adjusting
the print density" in this manual.
The media may be too damp. If media is damp, replace it.
Use a sealed media drawer.
Store the media in a sealed
package or bag.
The tracing paper has wrinkles. The media may be too dry. Use a sealed media drawer.
Store the media in a sealed
package or bag.
Image is missing on left and right
sides of the print when using the
Scale-to-fit option When using the Scale-to-fit option
the margins may have been set 0
(zero) Do not use a zero margin setting
when using Scale-to-fit. Try adding
a margin and increasing it, if
necessary, until the image is on the
print.