Zoom G1N - Manual (Page 13)

24 ZOOM G1N/G1XN
Effect Types and Parameters
25 ZOOM G1N/G1XN
Effect Types and Parameters
n MODULATION module
MODULATION (Type&Prm1) RATE (Prm2)
Selects the MODULATION module
effect type and controls parameter
1 at the same time.
Controls the value of parameter 2
of the MODULATION module. The
parameter action differs, depending
on the effect type.
C 1 C 9
Chorus
1 5 0
Rate
This effect mixes a variable pitch-shifted
component to the original signal. Higher
right-digit settings result in higher effect
sound mixing ratio.
Adjusts the modulation rate.
E 1 E 9
Ensemble
This is a chorus ensemble with three-
dimensional movement. Higher right-digit
settings result in higher effect sound mixing
ratio.
F 1 F 9
Flanger
1 5 0
Rate
This effect produces a resonating and
strongly undulating sound. Higher right-digit
settings emphasize the characteristics of the
effect.
Adjusts the modulation rate.
S 1 S 9
Step
Special effect that changes the sound in a
staircase pattern. Higher right-digit settings
emphasize the characteristics of the effect.
P 1 P 9
Pitch Shift
1 1 2
D T
2 4
2 1
Shift
This effect shifts the pitch of the original
sound up or down. Higher right-digit settings
increase the mixing ratio of the effect sound.
Sets the pitch shift amount in semitones. "dt"
results in a detune effect.
M 1 M 9
Mono Pitch
This is a monophonic pitch shifter (for
single-note playing) with reduced flutter.
Higher right-digit settings increase the
mixing ratio of the effect sound.
H 1 H 9
HPS
(Harmonized Pitch Shifter) C C O ,
D D O
F ,
,
E
F O G
,
A O B ,
G O A ,
Key
This is an intelligent pitch shifter that
automatically generates major scale
harmonies according to a preset key. Higher
right-digit settings increase the mixing ratio
of the effect sound.
Specifies the tonic for the scale used for
pitch shifting. The "o" symbol stands for #.
V 1 V 9
Vibrato
1 5 0
Rate
This is an effect with automatic vibrato.
Higher right-digit settings emphasize the
vibrato intensity.
Adjusts the modulation rate.
B 1 B 9
Pitch Bend
0 1 0
Pedal Position
This effect allows using the expression pedal
to change the pitch in real time. Right-digit
settings select the pitch change type caused
by the expression pedal (see Table 1).
Sets the initial value for the pitch shift
amount (the value that is active when the
pedal is at rest). The original sound/effect
sound level balance also changes according
to the parameter 1 setting.
b1
b2
b3
b4
b5
0 cent
0 cent
0 cent
0 cent
0 cent +1 octave
+2 octaves
-100 cent
-2 octaves
-
Pedal fully depressed
(maximum)
Pedal fully raised
(minimum)
Type&Prm1
[Table 1]
Prm2=0 Prm2=1.0
Pedal fully depressed
(maximum)
Pedal fully raised
(minimum)
Type&Prm1
Prm2=0 Prm2=1.0
b6
b7
b8
b9
-1 octave + original sound
-700 cent + original sound
Doubling
- (0Hz) + original sound
+1 octave + original sound
+500 cent + original sound
Detune + original sound
+1 octave + original sound
D 1 D 9
Delay
1 2 0
Time (Delay Time)
This is a delay with a maximum setting of
2000 msec. Higher right-digit settings
increase the mixing ratio of the effect sound
and the feedback amount.
Sets the delay time. In the 10 – 1000
millisecond range, the adjustment is
performed in 10-msec steps (1 – 99, 1.0).
Above 1 second, the adjustment is performed
in 100-msec steps (1.1 – 2.0).
n DELAY module
DELAY (Type&Prm1)
Selects the DELAY module effect type and controls parameter 1 at the same time.
D 1 D 9
Delay
This is a delay with a maximum setting of 5000 msec. The right-digit setting values control the mixing ratio
of the effect sound and the feedback amount.
T 1 T 9
Tape Echo
This effect simulates a tape echo with a long delay time of up to 5000 msec. The right-digit setting values
control the mixing ratio of the effect sound and the feedback amount.
A 1 A 9
Analog Delay
This effect simulates an analog delay with a long delay time of up to 5000 msec. The right-digit setting
values control the mixing ratio of the effect sound and the feedback amount.
P 1 P 9
Ping Pong Delay
This is a ping-pong type delay where the delay sound alternates between left and right. The right-digit setting
values control the mixing ratio of the effect sound and the feedback amount.
TIME (Prm2)
Controls parameter 2 of the DELAY module.
1 5 0
Time (Delay Time)
Sets the delay time. In the 10 – 1000 millisecond range, the adjustment is performed in 10-msec steps
(1 – 99, 1.0). Above 1 second, the adjustment is performed in 100-msec steps (1.1 – 5.0).