Lexicon CP-1 - Manual (Page 11)

Page 7
CP-1 Digital Audio Environment Processor
2
Connection
and
Calibration
Installation
• Make sure the remote control receiver, located on the right side of the
front panel, is unobstructed. The remote control must be in line of sight
to this receiver for proper operation. The CP-1 may be placed in a glass-
doored cabinet but smoked glass will make the display hard to read.
• Select a dry, well-ventilated location out of direct sunlight.
• Do not stack the CP-1 directly above heat-producing equipment such as
power amplifiers.
• Avoid placing the CP-1 near unshielded TV or FM antennas. The CP-1
may interfere with some FM tuners if it is placed immediately above or
below them.
• Install two AAA batteries in the CP-1’s remote control.
Precautions
The CP-1 may be installed on a shelf or in a standard 19" equipment rack,
using the optional rack-mounting hardware (Lexicon part #021-06639).
Connect the power cord to a wall outlet or to a switched outlet on the back
of your preamplifier. Observe the following precautions:
Connections to
Other Equipment
VCR
or
CASSETTE DECK
MAIN
OUT
TAPE
OUT/IN
AUDIO
OUT
I
II
TAPE
OUT/IN
REAR
MAIN
SIDE
PROGRAM EQ
or
DYNAMIC RANGE
PROCESSOR
VCR, TV, VIDEO
CONTROL CENTER
SIDE
AMPS
AUDIO
PREAMP
CP-1 INPUTS (SPEAKER
EQ)
REAR
AMPS
MAIN
POWER AMPS
CENTER
AMP
SUBWOOFER
AMP
CENTER
SUB
WOOFER
AUDIO or VIDEO
CASSETTE
RECORDER
MAIN OUT
AUDIO OUT
I
II
TAPE
OUT/IN
REAR
MAIN
SIDE
VIDEO
DISC
SIDE
AMPS
CD
CP-1 INPUTS
(SPEAKER
EQ)
REAR
AMPS
MAIN
POWER AMPS
CENTER
AMP
SUBWOOFER
AMP
CENTER
SUB
WOOFER
Using the CP-1 as an
Audio Preamp
Connections with an
Audio Preamp