Lexicon CP-1 - Manual (Page 37)

Page 33
CP-1 Digital Audio Environment Processor
Troubleshooting
Problem Possible Cause and Solution
Restoring defaults If severe power surges or sags cause problems with CP-1 memory
storage, or you simply want to start with a clean slate in the User
registers, you can restore factory presets into the User registers
with the following procedure. This will erase any programs you
have stored in the User register, so you may want to note any
settings you wish to re-use before proceeding.
Turn CP-1 power OFF. While pressing PARAM on the Remote
Control, turn power ON. (Make sure your hand does not block the
infrared receiver on the CP-1 front panel.) Continue holding
down PARAM until the display reads:
** TEST MODE **
PRM Key To Exit
Release PARAM and press EFFECT MUTE to clear and reload
User registers, and to restore all factory settings of Volume,
Balance, Contrast, Configuration, etc. The display will read:
RESTORE DEFAULTS
Press PARAM to restore normal operation. (Remember to check
the LCD contrast and Configuration settings, since they will have
been reset to factory defaults.)
If you cannot solve functional problems through these proce-
dures, consult your dealer or Lexicon/Customer Service Depart-
ment. DO NOT, UNDER ANY CIRCUMSTANCES, OPEN THE
UNIT. DOING SO WILL VOID YOUR WARRANTY, AND
MODIFICATIONS MAY RENDER THE UNIT UNSERVICE-
ABLE.