3M MP8780 - Manual (Page 13)

3M ™ Multimedia Projector MP8780 © 3M 1999
ENGLISH
12
Section 3: Basic Operations
3.1 Projector Startup
Figure 3.1 Projector Controls
1. Make all cable connections and line hookups with the power off.
2. Turn the POWER SWITCH of the projector on. The ON indicator will light up orange.
3. Press the STANDBY/ON button . The ON indicator blinks (green) and then lights (green).
The ON indicator will blink green during warm-up and lamp ignition. When power is turned off,
there is a 90 second reset period before the STANDBY/ON button will function again.
4. Adjust the screen size by pressing the ZOOM +/- button.
5. Adjust the sharpness by pressing the FOCUS +/- button.
6. Turn on all connected equipment. Refer to section 2.3.
7. Press the RGB/VIDEO button on the projector or remote to select the source of the signal
to be projected on the screen. The selected signal input is displayed at the top right of the screen.
The display will show the last selected input source before power was turned off.
3.2 Projector Shutdown
1. In projection mode, press the STANDBY/ON button. The Shut Down screen will display. Select
the
YES option (press arrow button or mini-joy stick) to turn off. The fan will continue to run for
approximately 90 seconds.
2. Turn the MAIN POWER SWITCH of the projector off.
3. Attach lens cap to protect projection lens.
4. Disconnect cables if moving projector to new location.
O I
O I
+
–
+
–
+
–
Select
Menu
Zoom Focus Volume
Blank
RGB
Video
Standby/On
Standby/On
Standby/On
O I
O I
Caution
Do not turn off the POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is
pressed, the fan rotates for about 90 seconds to cool the projector.