3M MP8610 User Manual
Page 28
24
3M
Multimedia Projector MP8610
3M 1998
8.
Synchronize the phase position of the pixel frequency and scanning frequency. Choose the menu
item Sync. Image interference’s and flickers can be observed with some settings as shown in the
following figure:
9.
In a range of several settings an image is projected that is free of interference. If the sync-setting
is correct, the image will improve as shown in following figure:
10.
An automatic setting of the synchronization can be called up by using the ENTER key.
11.
Minor interference, where one color meets another, can be corrected by manually adjusting the
Brightness and Contrast. Normally, the contrast should be set to approximately the medium
value. Lower values cause an increase in background intensity.
12.
Center the projected image using the H. off and V. off settings.
13.
To leave the Setup menu, press the MENU key.
14.
If parameter settings have been changed, a warning is displayed. Confirm the changed settings
by using the ENTER key.