Marksman Series X3 - Manual (Page 6)

6
87
87a
86 85
30
Brown Wire To +12V
To Horn
+12V or Ground Depending
on System Requirements
Fuse
Red/White Wire: (When programmed for (-) Domelight Supervision Output)
When Programmed for this function, the Red/White wire provides a (-) output to turn on the vehicles interior
light when the alarm has been disarmed. The domelight will stay on for 30 seconds unless the ignition key is
on.
87
86 85 30
Red/White Wire
(SPST ALA984H
Relay Not Supplied)
Output to Dome Light (+ or -)
To Constant +12 Volts
Input to Relay (+ or -)
Brown Wire: (When programmed for (-) Horn Output)
When Programmed for this function, the Brown wire provides a (-) output to use the vehicles horn as the
primary sounding device. Locate the horn button wire at the base of the steering column.
Note: Some vehicles will require an additional relay.
With the ignition switch in the OFF position, turn the
key On
Step 1
Programming the Remote Transmitter
Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the security system will start deleting transmitters from memory in chronological order.
Before 15 seconds has passed, push and release the valet
switch 3 times. THe siren will emit 1 long + 1 short chirp.
You are now in “Transmitter Programming” mode.
Step 2
3X
Optional Wiring Diagrams
Programming the Transmitter