3Com WX4400 3CRWX440095A - Manual (Page 188)

188 C HAPTER 10: C ONFIGURING MAP A CCESS P OINTS
Dual-Homed Distributed Connections to WX Switches on One
MAP Port
Figure 13 shows an example of a MAP with a single physical
link to a network containing three WX switches.
Figure 13 Single-homed Connection to Multiple WX Switches on One MAP Port
In this configuration, the MAP sends a boot request on its connected
port. WX switches in the same subnet respond to the MAP. WX switches
with high bias for the MAP respond immediately, whereas WX switches
with low bias for the MAP respond after a brief delay.
If the switches are in another subnet, the MAP uses DNS to locate one of
the switches, and asks the switch to send the IP address of the best WX
to use, based on the bias settings on each switch and the capacity of
each switch to add new active MAP connections. The MAP then requests
its image and configuration files from the best WX.
Network
backbone
WX switch
WX switch
WX switch