3Com WL-603 - Manual (Page 45)

Accessing the Setup Wizard 43
Bridge Mode (for a single PC)
Selecting the Bridge mode sets the device into 1483 bridging mode in
which the device connects LANs and WAN together. It operates as a Data
Link Layer device that acts to limit the traffic between two network
segments by filtering the data between them based on the hardware
address.
To set up the Router for use with an RFC1483 bridged connection, use
the following procedure:
Figure 29 Bridged Mode Screen
1 Enter your VPI and VCI information in the VPI/VCI fields.
2 Select the encapsulation type (LLC or VC MUX) in the Encapsulation
drop-down menu. This information should be provided to you by your ISP.
Check all of your settings, and then click Next.
The LAN Settings screen will then be displayed (refer to
Figure 32 ).