Edimax Technology ES-5224RS+ - Manual (Page 39)

User Manual
Publication date: July, 2006
Revision A2
33
Speed Duplex:
Display the speed and duplex of all port. There are three speeds 10Mbps,
100Mbps and 1000Mbps supported for TP media, and the duplex
supported is half duplex and full duplex. If the media is 1Gbps fiber, it is
1000Mbps supported only. The status of speed/duplex mode is
determined by 1) the negotiation of both local port and link partner in
“Enable” mode or 2) user setting in “Disable” mode. The local port has to
be preset its capability.
Flow Control:
Show each port’s flow control status.
There are two types of flow control in Ethernet, Backpressure for half-
duplex operation and Pause flow control (IEEE802.3x) for full-duplex
operation. The switch supports both of them. Default: Enabled
Fig. 3-7
Parameter description for Port Configuration:
State:
Show if the communication capability of the port is Enabled or Disabled.
When enabled, traffic can be transmitted and received via this port.
When disabled, the port is blocked and no traffic can be transferred
through this port. Admin function is configurable by the user. There are
only two states “Enable” and “Disable” able to choose. If you set a port’s
state “Disable”, then that port is prohibited to pass any traffic, even it
looks Link up.