Edimax Technology PS-1206MFG - Manual (Page 21)

13
network, the MFP Server will automatically obtain and configure the
network settings assigned by the DHCP Server. The assigned IP Address
will be shown in the IP Address fields. If no DHCP Server is present within
the network, please assign the network settings of the MFP Server
manually. Please click “Next” once you have found appropriate network
settings for the MFP Server.
Note: The MFP Server IP Address should be in the same network
segment with the connected computer. If the network settings are incorrect,
a message will be prompted to remind you after you click “Next”. Please
make sure that you have set the right settings before going to the next step.
If you don’t want to set it now, please click “Cancel” to finish the installation.
You can then use the “Server Manager” utility to configure the MFP
Server.
13. The “Wireless Network Settings” screen will allow you to connect your
wireless MFP Server to your wireless router, access point, or point-to-point
ad-hoc connection.
The MFP Server will automatically scan the wireless networks nearby.
Please select the appropriate wireless network that you would like to
connect from the list and click “Next”.
You may choose to scan for the wireless access point or router
(Infrastructure mode) or the wireless adapters (Ad Hoc mode). Or, you can