Hama BC-400D - Manual (Page 19)

36 37
Scanned the correspondi-
ng code unsuccessfully Parent unit: Parent unit:
Baby unit: Baby unit:
Remarks: If operated by the supplied adaptor, please fi rst plug in the adaptor, then
power on the unit. And then scan the corresponding code with the LINK key if need.
C. 2-Way Communication
Usually, the detected sound is transmitted from the Baby unit to Parents unit. But
Parents unit can talk to Baby unit with its TALK key.
1. Press and hold TALK key of Parents unit and talk to the Baby unit.
2. Release the TALK key, the Parents unit is in receiving status and wait for signal from
Baby
unit.
Remarks:
When pressing TALK key, the Parents unit does not receive any sound from Baby unit.
D. Music Control (optional)
After activating Music Play function of both units, as long as one of them adjusts music
play or changes music(01-06 or AL), the setting for this function of the other unit will
change accordingly.
Trouble shooting
Problems Solutions
1. No power - Unit is turned off.
- Check if the batteries are installed properly.
- Make sure the adaptor is connected to the Unit
properly if using the adaptor instead of batteries.
- The Unit may be in low battery status, change new
batteries.
2. Message not
transmitted - Sound sensitivity level of Baby unit is too low, turn the
sound sensitivity switch to “HI” position.
- Units are out of range or lost connection. Ensure the
distance between the units within communication range.
Note: Communication range varies depending on
surrounding conditions such as physical obstructions,
interference.
- Make sure the TALK key of Parents unit is not pressed.
- Make sure the unit is unlocked.
- Ensure both units have already scanned the
corresponding code.
3. No sound signal - Volume level on Parents unit is set too low. Adjust it to
higher volume.
- Sound sensitivity level of Baby unit is too low, Turn
the Sound Sensitivity switch to “HI” positions.
- Units are out of range. Ensure the distance between
the units within communication range.
- Make sure the TALK key of Parents unit is not pressed.
- Make sure the unit is not locked key.
- Ensure both units have already scanned the corresponding
code.
4. Received
conversation or
sound from
neighbors. - Signal interference due to other nursery monitor on the
same ID Code or cordless phone used.
- Change both units to another ID code by pressing LINK key.
fl ashing
orange light
fl ashing
orange light
still
fl ashing
still
fl ashing
00092661man_de_el_en_es_fr_it_nl_ru_Teil1.indd 38-39 00092661man_de_el_en_es_fr_it_nl_ru_Teil1.indd 38-39 03.08.10 13:32 03.08.10 13:32