Yamaha PSR-520 - Manual (Page 52)

51 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Song Recording
● Enter a New Name for the Song
If you want to enter a descriptive name for the user songs numbered 26
through 33, enter your original Song name, this is recommended.
Use the cursor [>] button to move the cursor to the first (left most) char-
acter of the Song name in the display. A Song name can consist of up to 8
characters. The position of the character you want to enter or change can be
selected by moving the cursor.
Using the [–/NO] and [+/YES] buttons or the data dial, enter the desired
character listed below. The number buttons can also be used to enter the
number. If you want to insert an underline character at the cursor position,
press the cursor [▲] button. If you want to delete a character at the cursor
position, press the cursor [▼] button. When you’ve finished entering the
Song name, move the cursor to the position other than the Song name so
that the newly entered Song name will be memorized.
Character List
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789–
Keiji 1 26
• The Song data including it’s
name is retained in memory even
when the power switch is turned
OFF, as long as the batteries are
installed or the AC adaptor is
connected.
Play the required chords in the Auto Accompaniment section of the key-
board. If you’ve also selected the MELODY track to be recorded, play the
melody on the right-hand section of the keyboard. The MEASURE number
on the display will increment as recording progresses.
MEASURE
a 02
5
Stop Recording
..............................................................................................................................................
Stop recording by pressing the SONG [PLAY/STOP] button, the AUTO
ACCOMPANIMENT [START/STOP] button, or stop with an ending by
pressing the AUTO ACCOMPANIMENT [ENDING] button. The [REC]
button indicator will go out and the MEASURE number on the display will
return to “01”.
The ACCOMP track volume setting will appear on the display.