ROWENTA BRUSH ACTIV VOLUME & SHINE CF9320 - Manual (Page 60)

THE FINISHING TOUCHES
Fringes
For a short, straight fringe, we suggest using the small-diameter brush, which
will give more movement.
For straight fringes, you will need
to give more volume at the root
to give the best profile.
For a longer fringe, on the other hand, the large-diameter brush will give a smoother effect. On a
damp, pre-dried fringe, place the brush under fringe, from the roots, and keep the automatic
rotation on to roll the section to the inside until completely dry.
Volume
at the roots
Once the hair is blow dried, place the brush at the root again, under the section
(preferably the large-diameter brush), without using the automatic rotation.
Setting: drying only. Start smoothing the section against the lie of the hair for
about 3 cm from the roots and then allow the appliance to slide slowly to the tip of the section
without stretching it.
Then bring the section back to the correct side.
Replacer ensuite la mèche du bon côté.
To give more volume to all of your hair, it is important to use this tip on each section of hair.
BLOW DRYING
Curled and light
This technique is essentially for use on short and medium-length hair, soft or wavy.
Curls and waves are made by rolling fine sections of hair around the small-diameter brush: the finer
the section, the tighter the curl.
Always start at the nape of the neck, working progressively upwards, and finish with the sections at
the top of the head.
Place the brush alternately under the section (to dry the roots) and then over the section (for the
wave) in a relatively slow rotating movement, which will give more
volume and an effect of lightness.
The rolled sections must cool without being touched.
Once all the hair is dry, arrange the curls and waves using your
fingertips.
Avoid using a comb or brush, which would spoil the effect.
EN
Professional_tips_tricks_hairdress_p1_A5 13/06/12 15:10 Page4